Antiquing, without the use of a finish sprayer.


The seal coat has been allowed to cure.

Watco is again flooded onto the surface.

A medium ScotchBrite pad is used to rub the Watco in. This loosens the previously sealed dye, giving the worn appearance.

The amount of dye removed, and where, is easily controlled by how much rubbing is done with the pad. Don't press down hard, as this makes the process harder to control and more tiring.

Here is my test board with the dye rubbed away from the middle.

I felt the contrast was a little high, so while it was still wet, I applied a coat of Cherry colored Watco. This adds just a little overall red tone back in.


To beginning>> Antiquing